Two steps to winterize your ICO

Winterizing your ICO is just as important as winterizing your pool. If you wish to winterize your spa, you must also winterize your ICO SPA. Please follow this process. It's part of good practice to preserve the life and reliability of your sensors and battery.

Here are two steps to winterizing your device plus the ICO application.

visual winterizing the ico pool connected sensor

First step: winterize your ICO device

Your ICO unit is winterized at the same time as your pool, i.e. when the water temperature reaches 12°c. Click in the link to follow our guideline how to winterize a pool.. Our advice onwintering your spa.

Protect sensors with KCl storage liquid

  • Remove ICO from the water and wipe it with a clean soft cloth.
  • Remove the lower part of ICO to access the sensors: to do this, turn the cover to the left a quarter-turn.
  • Clean the sensors with mineral water, carefully removing any impurities.
  • Pour KCl storage fluid over the yellow sponges inserted in two black caps for pH and ORP/ REDOX sensors only.
  • Leave the sensors immersed for 1 hour.
  • To protect the probes in winter : Moisten the sponges with a KCl solution (ideally), otherwise mineral water, then replace the black protective caps. Repeat this procedure as many times as necessary until your ICO is up and running again.
  • Replace the bottom cover: store ICO in its protected box away from dust.
  • Open the top cover: long press (5-6s) to turn it off. The LED will flash yellow once. Replace the cover.
Winterize ICO sensors by moistening the small yellow sponges with KCl (potassium chloride) solution.

Store your ICO over winter

Once your device has been switched off and your probes protected, store it in a clean and dry place. The temperature of the storage room should not fall below 5°c , as too cold a temperature could damage the sensors. Now all you have to do is winterize the ICO application as described below until the next season!

Step 2: Activate wintering mode in the ICO application

Open the app  : select the pool to winterize

Click on the icon settings and then on My pool / My spa.

In the section Winteringselect Activate / Deactivate

In the section Wintering select Activate / Deactivate, and then activate « Winterize my pool /spa » and click on Continue.

When the winterizing mode is on , a snowflake icon appears on your pool profile. Access to data is temporarily disabled until your pool is opened.

To reactivate your ICO, click on the snowflake and validate "end of winterizing".

Other articles

Need more help ?

en_GBEN